HP Netserver LH 3/LH 3r Processor Upgrade Guide
1
1 Processor Module Installation
About This Upgrade Accessory
This accessory kit is provided as an upgrade to both the HP NetServer LH 3 (the
floor-standing pedestal configuration) and LH 3r (the rack-optimized
configuration). This upgrade accessory may be used to replace an existing
processor module with a higher-speed processor, or to add a second processor
module to a single-processor system.
In a dual-processor configuration, both processors must be the same speed.
Installation Overview
This guide describes the tools required and the procedure for installing a
Pentium II
™
processor module into the HP NetServer. The installation procedure
includes instructions on how to:
• Remove the NetServer bezel and covers
• Remove the HP NetServer LH 3r system board
• Remove the existing processor module or terminator board (if necessary)
• Install a new processor module
• Install a new voltage regulator module (VRM)
• Install the system board
• Replace the covers
• Update the BIOS
NOTE All components of the upgrade kit must be installed in order
for the upgrade to function properly.