HP NetRAID DIMM Installation Guide

5
Installation
A. Shutting Down and Disconnecting Power
Do the following to prepare for installation:
1. Bring down the NetServer’s operating system properly to make
sure that cache memory has been flushed.
2. Turn the NetServer power off.
3. Disconnect the power cord(s).
CAUTION Be sure the HP NetServer is turned off and
disconnected from AC power before you remove or
install the HP NetRAID DIMM.
B. Removing Cover 1
If your HP NetServer is mounted in a rack, extend the rack chassis
antitip foot or ensure that the anti-tip feature is installed. Then slide
out the NetServer until the slide locks into place. See your rack
documentation and the HP NetServer installation guide for more
information.
Remove Cover 1, shown in Figure 1, by following the directions in the
HP NetServer installation guide.