HP NetRAID DIMM Installation Guide

G. Restarting the HP NetServer

1. Connect the power cords and all other external cables.

2. Turn on the HP NetServer, and verify that it starts properly.

◊ If the HP NetServer is operating in HP NetRAID mode, the

HP NetRAID Adapter BIOS version is displayed, firmware

initializes, and then DRAM = displays the capacity of the

HP NetRAID DIMM.

◊ If you receive error message 0076-98: Could not configure

the i960

I/O processor’s subsystem IDs, the HP NetRAID

DIMM is not seated properly in its socket. To correct the

problem, repeat the installation procedure.

NOTE If you need to change to HP NetRAID mode, refer to

Step D in Chapter 5 of the Integrated HP NetRAID

Controller Configuration Guide.