HP Netserver LC 2000 Pedestal-to-Rack Guide

Chapter 2 Rack Mounting the HP NetServer
14
6. Hold a slide in position inside the two left-hand rack columns and
observing the following items.
a. The mounting flange on each end of the slide must wrap around the
outside face of both the front and rear columns. See Figure 2-6.
b. The two holes in the mounting flange should line up with the captive
nuts (at 7th and 9th holes) in the column adapter and the two rack nuts
you installed on each rear column.
c. The extending portion of the slide (slide member) should point forward
out of the rack.
Extend rack’s
anti-tip foot
from front of rack
for safety.
Mount Slides
inside Column
Adapters
Figure 2-6. Securing the Slides to the Rack Columns