HP Netserver LP 1000r User Guide
Chapter 1 Controls, Ports, and Indicators
5
• The Video Port interface specifications are listed in Table A-4, "HP
Netserver Hardware Specifications" and Table A-5, "Video Display
Modes" of Appendix A, "Specifications."
• The two LAN ports (LAN A/MGMT and LAN B) are for embedded
controllers based on Intel’s 82559 10/100 BaseT Fast Ethernet controller.
Only LAN A/MGMT is used with Alert-on-LAN 2 (AOL2) and Wake-on-
LAN remote management functions. Each one has a RJ-45 LAN
connector and two LEDs to indicate LAN speed and valid connection.
Refer to Table 1-3 for the LAN LED indicators and Chapter 10,
"Configuring the HP Netserver."
• The external SCSI port provides access to external SCSI devices, typically
an external SCSI tape back-up device.
Power Mouse
Parallel
LAN B
PCI Slot (1)
External
SCSI Connector
Video
USB (2)Keyboard
LAN A/MGMT
Serial A/MGMT
Figure 1-3. Rear Panel and Ports
Table 1-3. LAN Port (RJ45) LED Indicators
Indicator Definition
Link LED
This green LED is the activity/link indicator.
• Steady On indicates a valid LAN link.
• Flashing On indicates there is LAN activity.
LAN Speed Indicator
This yellow LED is the LAN speed indicator.
• Steady Off indicates the LAN is operating at
10 Mbps LAN speed.
• Steady On indicates the LAN is operating at
100 Mbps LAN speed.