HP Netserver LP 1000r User Guide

Chapter 12 Troubleshooting
105
Table 12-1. POST Error Messages
Message Corrective Action
Operating
system not found
• Verify the desired boot drive has power and its
SCSI cable connected.
• Verify the SCSI cable is securely plugged into the
SCSI connector on the system board.
• Verify the boot device is enabled in the Setup
Utility under the Security menu.
• Verify the boot device has an operating system
installed.
If the problem persists, contact your HP support
organization.
Keyboard error
(The LP 1000r
will complete the
boot process
without a
keyboard
connected.)
• Verify the keyboard is connected to the correct
connector (not the mouse connector) at the rear of
the Netserver.
• Verify the connector is pushed completely.
If the problem persists, replace the keyboard or
contact your HP support organization.
Mouse error
(The LP 1000r
will complete the
boot process
without a mouse
connected.)
• Verify the mouse is connected to the correct
connector (not the keyboard connector) at the rear
of the Netserver.
• Verify the connector is pushed completely.
If the problem persists, replace the mouse or
contact your HP support organization.
If no message
appears (screen is
blank)
• If no text or messages appear listen for the beep
codes. Refer to the beep codes listed in the HP
Netserver LP 1000r Service Manual.
• If no message appears but the Netserver stops after
POST, verify the DIMMs are correctly installed.
• If you suspect the BIOS is corrupted, refer to
"Clearing the CMOS Configuration," and restart
the Netserver.
If a config-
uration error
occurs
If a Netserver configuration error is reported during the
startup routine, clear the CMOS memory as described
under "Clearing the CMOS Configuration," and restart
the Netserver.