HP Netserver LP 1000r User Guide

Chapter 12 Troubleshooting
107
7. Turn on power to the Netserver and the following message displays:
Incorrect System Configuration
8. Press <F2> to run the Setup Utility when <F2=Setup> appears.
9. Make any configuration changes required.
10. Choose the Exit option and save the changes to save the configuration and
exit the Setup Utility.
Configuration Switch
Spring Latch Battery
Switch 1 Position
Figure 12-1. Configuration Switch Location
Clear CMOS
Clear Password
Open
Shaded rectangle
represents the position
of switch.
Open = Off Closed = On
Not Used (Default = Off)
Not Used (Default = Off)
Rear of Chassis
BIOS Recovery
Figure 12-2. Configuration Switch Positions