HP Netserver LP 1000r User Guide

Chapter 12 Troubleshooting
112
9. Ensure the spring latch holds the battery firmly.
10. If necessary, replace the PCI board and replace the top cover.
11. Re-install the Netserver into the rack.
12. Power on the Netserver and reset the CMOS settings.
Problems Running the Setup Utility
If you cannot run the Setup Utility, the HP Netserver’s configuration in CMOS
memory may have become corrupt. The only way to recover from a corrupted
configuration is to clear it. Refer to "Clearing the CMOS Configuration," earlier in
this chapter.