HP Netserver LP 1000r User Guide

Chapter 13 Alternative Rack Mounting (4–Post)
120
View Rotated 90 Degrees CCW
Spring Tab
Figure 13-5. Releasing the Outer-Rail Assembly
Placing the HP Netserver in the Rack
Use this topic to insert the HP Netserver into the outer-rail assembly mounted in
the rack. Once the Netserver is in the rack, you can connect the cables to the rear
of the Netserver.
WARNING To prevent rack instability while mounting the HP Netserver,
ensure the rack’s anti-tip foot is pulled forward out of the
bottom of the rack. Failure to do so could result in injury and
equipment damage.
To prevent the rack from rolling while you mount the HP
Netserver, ensure the leveler screws on the rack’s lower four
corners are in firm contact with the floor. See Figure 13-4.