HP Netserver LP 1000r User Guide

Chapter 13 Alternative Rack Mounting (4–Post)
122
The securing brackets on the front of the Netserver should stop the chassis
from going all the way into the rack.
6. Secure the Netserver chassis to the rack with captive screws.
Attaching the Front Bezel
The front bezel attaches to the HP Netserver by pivoting on two pins at the bottom
and grasping the top pins with spring latches. The middle pins force the bezel to
pivot in or out, ensuring a rotating action.
1. Position the Bezel in front of the HP Netserver LP 1000r as shown in
Figure 13-7.
2. Push in on the bottom to engage the pins, allowing it to rotate up.
3. Push the bezel in at the top to engage the spring latches.
The spring latches should click when engaged.
Pins
Spring
Latches (2)
Figure 13-7. Attaching the Bezel to the Netserver
Continuing with the Rack Installation Process
After you install the HP Netserver in the rack, refer to the white paper, located on
the HP web site for high-density rack configurations, to continue the process of
installing and configuring the rack system. The white paper is titled
HP Netserver High Density Rack Solutions Overview (LP 1000r and LP 2000r).