HP Netserver LP 1000r User Guide

Chapter 3 Installing Mass Storage Devices
25
2. Disconnect the SCSI cable end connected to the SCSI A cable connection
on the system board. See Figures 3-6 and 3-7.
3. Unfold the cable and connect it to the SCSI connector on the HP NetRAID
Controller board before installing the board into the Netserver.
SCSI
Connector
SCSI
Backplane
Board
Leave SCSI
cable connected here.
Figure 3-6. SCSI Backplane Board
Disconnect
SCSI A end of
Cable.
SCSI Backplane Board
Figure 3-7. Disconnecting SCSI A Cable