HP Netserver LP 1000r User Guide

Chapter 5 Installing Additional Boards
43
16. Once the Netserver is returned to normal operation, you may need to install
software drivers.
The drivers for the new PCI board are either part of your existing system
software or included on a flexible diskette or CD-ROM provided with the
accessory board.
Board
Clamp
Tab Rest
Step C
Lower Board
Step A
Open Clamp
Step D
Close Clamp
Step B
Insert
between tabs
Latch
Figure 5-6. Clamping Long PCI Boards
Removing the Accessory Board
Follow the same steps as the installation procedure, but in reverse order. Replace the slot
cover. See the preceding sections for details.