HP Netserver LP 1000r User Guide

6 Installing an Additional Processor

Introduction

The HP Netserver LP 1000r ships with at least one processor on the system board

(primary processor socket – CPU 1) and the voltage regulator modules (VRMs)

are embedded in the system board. Both processor sockets (primary and

secondary) are located on the system board.

Tools Required

The following tools are required to access and install or remove the processors:

• ¼-inch flat blade screwdriver

• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit

includes a static-dissipating work surface, a chassis clip lead, and a wrist

strap.

Processor Configuration Guidelines

The HP Netserver LP 1000r supports a variety of processor speeds with an FSB

(front side bus) speed of 133 MHz. The Netserver supports processor speeds at

866, 933 MHz and 1 GHz.

NOTE Some processor speeds listed for this HP Netserver may not be

supported. For the latest support information, visit the HP web

site:

http:/www.hp.com/netserver

CAUTION Do not open the new processor's protective bag or remove the

processor from the bag until you are ready to install it.

Before you remove a processor from the anti-static bag, touch

a grounded, unpainted metal surface on the HP Netserver to

discharge static electricity.

• Both processors must be the same processor type and have the same

product number, which insures the same clock speed, cache size, and FSB

speed.