HP Netserver LP 1000r User Guide

Chapter 6 Installing an Additional Processor

Refer to Chapter 2, "Opening and Closing the HP Netserver," to gain

access to the system board.

NOTE It is not necessary to remove the system board from the

Netserver to install the second processor (CPU 2).

6. Loosen the two captive screws holding the air duct over the DIMM slots

and remove the air duct. See Figure 6-2.

Figure 6-2. Removing the Air duct

7. Ensure the processor speed of the second processor (CPU 2) is the same as

the existing processor before installing the second processor.

NOTE If you are upgrading the second processor to a faster processor

speed than the primary processor, the primary processor must

also be changed. Both processors must have the same product

number, which includes the same clock speed, cache size, and

FSB speed.

The supported processors only perform at the rated speed

indicated on the processor in the HP Netserver.