HP Netserver LP 1000r User Guide

59
7 Rack Mounting the HP Netserver
(2-Post)
Introduction
This chapter provides the instructions for mounting the HP Netserver in a
two-post (column) non-HP rack. The illustration below shows the characteristics
of the 2-post (CPI – Chatsworth Products Inc.) rack. If you have one of the
four-post HP racks, see Chapter 8, "Rack Mounting the HP Netserver (4-post)," or
Chapter 13, "Alternative Rack Mounting (4-post)," for instructions. If you are
mounting the Netserver in a non-HP rack, refer to the documentation in the
appropriate rack accessory kit.
Characteristics of
2-Post Rack:
A. U-shaped column for easy
access
C. Base is bolted to floor.
B. Top is secured to
ceiling to hold
additional weight.
A
B
C
Figure 7-1. Features of 2-Post Rack