HP Netserver LP 1000r User Guide

Chapter 7 Rack Mounting the HP Netserver (2-Post)
68
Figure 7-7. Center Mounting in the Rack
Attaching the Front Bezel
The front bezel attaches to the HP Netserver by pivoting on two pins at the bottom
and holding onto the top pins with spring latches. The middle pins force the bezel
to rotate in or out, ensuring a rotating action.
1. Position the Bezel in front of the HP Netserver LP 1000r as shown in
Figure 7-8.
2. Push in on the bottom to engage the pins, allowing it to rotate up.
3. Push the bezel in at the top to engage the spring latches.
The spring latches should click when engaged.