HP Netserver LP 1000r User Guide

Chapter 8 Rack Mounting the HP Netserver (4-Post)
79
6. Repeat Steps 3 through 5 for the outer-rail on the right front and rear
columns.
7. If you need to release the outer-rail assembly once it is installed into the
rack, do the following:
a. Place your finger inside the rail at the point shown by the arrow to
release the spring tab. See Figure 8-5.
b. Press in on the spring tab and pull the outer-rail assembly toward you at
the front of the rack. See Figure 8-5.
View Rotated 90 Degrees CCW
Spring Tab
Figure 8-5. Releasing the Outer-Rail Assembly