HP Netserver LXr Pro8 Memory Board

Chapter 2 Installing Memory in the 4 GB Memory Board

Tools Required

To remove or install a memory board, first remove the satellite chassis lower fan

module and the rear access panel. These tools are required for removal and

installation of accessories:

• Number 1 Phillips head screwdriver

• An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit

includes a static-dissipating work surface, a chassis clip lead, and a wrist

strap.

Power-Down Procedure

Power to the satellite chassis must be turned off before removing or installing the

4 GB memory boards.

1. Save your existing system configuration.

2. Log off all users, shut down all networking software, applications, and the

operating system.

3. Press the DC power switch on the HP NetServer's control panel (Figure

2-4).