HP Netserver LXr Pro8 Memory Board

Chapter 2 Installing Memory in the 4 GB Memory Board
9
Power
LED
AC Power
LED
DC Power
Switch
Figure 2-4. HP NetServer Control Panel
4. Unlock the power interlock switch at the back of the HP NetServer's rear
panel by turning it clockwise (Figure 2-5). The switch turns off DC power
to the HP NetServer, and also unlocks the satellite chassis. See the HP
NetServer LXr Pro8 User Guide for more details on opening and closing
the HP NetServer chassis.
NOTE After you unlock the power interlock switch, DC power is
turned off for all components within the satellite chassis
except for five volts at the system control board which is
located on the SCSI Extender Tray in the bottom of the lower
board cage area. If you undock the satellite chassis from the
base unit, there is no power present at any internal or
externally-accessible area of the satellite chassis. However,
five volts are still present at the power supply connector where
the satellite chassis attaches. To remove all power, unplug the
AC power cord.