HP Netserver Service Handbook, Volume 1 - Low End

20
To save the configuration values and reboot the system so that these values take effect, press
Esc and then F4.
To exit from Setup without changes, press Esc and F6.
Exiting Setup
After you have made all desired changes to the Setup Utility pages, press Esc to display the Exiting Setup
menu.
Press F4 to save the changes and reboot the system. If you want to exit without saving the changes, press
F6.
NOTE If you change any of the three video refresh rates, you must either press the reset
button or turn the system off and back on after you exit Setup in order to make those
changes effective.
Setup Program - HP NetServer E Series
The integrated (ROM-based) Setup program displays the NetServers configuration and allows you to set
certain parameters. Setting incorrect values may cause system boot failure. Should this occur, press [F9].
This will load default values to recover.
The Setup program is menu-driven, and menus are grouped in the following categories: Main, Preferences,
Configuration, Security, Power, Boot, and Exit. Some categories give sub-menus. Menu items that have sub-
menus are indicated.
You will probably not need to change most of the parameter settings shown in the Setup program. However,
if additional accessories are installed in the NetServer, you should check that they have been recognized by
the Setup program or modify the configuration manually.
NOTE If you are unable to change the NetServers configuration, check that you entered the
correct password when you started Setup. Check also that the system board switch 8
is not set to the closed position
The Setup program is accessed by pressing [F2] during the NetServers power-on system hardware test.
On-line help is provided, in English only, at the right-hand side of the screen for each item. The help for the
item is displayed when you highlight the item.
Saving Changes to the Setup Configuration
When you have finished updating the NetServers configuration, or you have verified that the installed
components have been correctly detected:
Press [F3] to save any changes you have made and exit the Setup program.
Press [F12] to exit the Setup program without saving any changes.
The NetServer will continue its startup process as usual.
PrintCFG Utility
The PrintCFG Utility lets you view information about CFG files and the boards they represent. You can
display this information on the screen, or print it.