HP Netserver Service Handbook, Volume 2 - Mid

36
NOTE In order to optimize PCI board BIOS installation, you need to leave the largest open
range of memory possible. Group the EISA and ISA board BIOSs at either the
beginning or end of the 0C8000h through 0DFFFFh range.
Cabling Configurations
Duplex, Non-Disk Array Model with Internal Controller
This is a standard mass storage configuration as shipped from HP.
NOTE If you are installing Ultra SCSI mass storage devices in this NetServer, you must
enable Ultra SCSI.
SCSI or IDE
Device
SCSI or IDE
Device
CD-ROM
System Board
IDE
SCSI A
Connector
Flexible Disk
Drive
I 2
C
C31
C22
SCSI Terminator
built into cable
T
B1
(Rear View)
Default Switch Settings
1
2
3
4
5
6
ID
3
ID
0
ID
1
On
Off
This is the default SCSI switch setting for this configuration.
SCSI ID 2 is reserved for an optional DAT (Digital Audio Tape)
drive that can be installed in upper drive tray 3 or 4. The
standard CD-ROM drive is shipped with SCSI ID 5.