HP Netserver Service Handbook, Volume 2 - Mid

37
Duplex Disk Array Configuration with Dual Channel PCI Controller Board
This is one of several possible optional mass storage configurations. You are not limited to the configurations
shown on this CD-ROM; this is only given as an example.
SCSI or IDE
Device
SCSI or IDE
Device
CD-ROM
System Board
IDEIDE
SCSI A
connector
Flexible Disk
Drive
I
2
C
C31
C22
C22
SCSI Terminator
built into cable
T
A
B1
(Rear View)
PCI DAC Board
Channel 0
Channel 1
68-Pin
to
50-Pin
Adapter
Default Switch Settings
1
2
3
4
5
6
ID
3
ID
0
ID
1
On
Off
This is the default SCSI switch setting for this configuration.
SCSI ID 2 is reserved for an optional DAT (Digital Audio Tape)
drive that can be installed in upper shelf 3 or 4. The standard
CD-ROM drive is shipped with SCSI ID 5.
Configuring Switch Settings on the Hot Swap Subsystem
Switches 3 and 4 determine the SCSI address of each of the shelves. Possible switch settings are given in
the table below.