HP Netserver Service Handbook, Volume 2 - Mid

61
NC
3.3V
NC
GND
GND
PS REMOTE
PS ON
SW1 Switch and Default Settings
ON
8
7
6
5
4
3
2
1 FLASH WRITE ENABLE
BOOT LOCK DISABLE
CONFIG VALID
CONFIG UNLOCK
PASSWORD ENABLE
SMI# ENABLE
IO CTRL ENABLE
VIDEO ENABLE
Switch Function Default
1 FLASH WRITE ENABLE: Enables or disables one of the two levels of
flash ROM write protection (the other level of protection is controlled by
the HP Update Utility).
ON: The BIOS can be updated by the HP Update Utility.
OFF: The BIOS is locked and cannot be updated.
ON
2
BOOT BLOCK DISABLE: Reserved. Must be set to ON for system to
operate properly.
ON
3 CONFIG VALID: Saves or erases the current configuration information
in NVRAM and CMOS.
ON: Saves the current configuration.
OFF: Erases the current system configuration.
ON
4
CONFIG UNLOCK: Prevents or allows the current system configuration
maintained in NVRAM and CMOS to be changed.
ON: Unlocked. Allows the current system configuration to be changed.
OFF: Locked. Prevents the current system configuration from being
changed.
ON
5 PASSWORD ENABLE: Enables or erases the power-on password
maintained in NVRAM.
ON: Power-on password functional.
OFF: Erases the current power-on password.
ON
6
SMI# ENABLE: Not used. Leave set on default.
OFF: Prevents SMI interrupt.
OFF
7 IO CTRL ENABLE: Enables or disables onboard flexible disk drive
controller, IDE controller, and serial and parallel ports.
ON: I/O controller enabled.
OFF: I/O controller disabled.
ON
8
VIDEO ENABLE: Enables or disables built-in video. Disable the built-in
video only if you have a separate video board installed in the server.
ON: Enables built-in video.
OFF: Disables built-in video.
ON