HP Netserver Ultra3 SCSI HBA Guide

Figure 1-8. Connecting Ultra/Fast Wide SCSI Devices

2. Plug the other end of the cable to a terminated Ultra/Fast Wide SCSI device.

3. If you have other Ultra/Fast Wide SCSI devices, attach them to the

connectors between the two ends of the cable. Be sure these other devices

are unterminated.

4. Connect a power cable from your HP Netserver’s internal power supply to

each internal device.

Connecting Internal Ultra/Fast Narrow Devices

Connect internal Ultra/Fast Narrow SCSI devices that have standard 50-pin

connectors to the 50-pin internal SE Narrow SCSI connector. To do this, use a

50-pin internal SCSI cable. Follow these steps to connect the devices:

1. Plug one end of the cable to the 50-pin internal SE Narrow SCSI connector

on the HP Ultra3 SCSI host bus adapter.

68-pin flat SCSI cable