HP Netserver Ultra3 SCSI HBA Guide

12
NOTE We recommend that you connect only Ultra3 and Ultra2 SCSI devices
to the external SCSI connector. If you also attach older Ultra SCSI
devices, the data transfer speed of the Ultra3 and Ultra2 SCSI devices
will drop to the speed of the older devices. (See BusSegmentsonthe
HP Ultra3 SCSI Host Adapter on page 2.)
Follow these steps to connect the external devices:
1. Connect one end of the external LVD SCSI cable to the external LVD/SE
connector on the HP Ultra3 SCSI host bus adapter.
Figure 1-10. Connecting External SCSI Devices
2. Connect the other end of the external SCSI cable to a SCSI connector on the
back of an external SCSI device. If you are installing only one external
device, terminate the device and skip to Step 4.
3. Connect other external devices by cabling each device to the previous one,
as shown below.
SCSI T erminator
SCSI Terminator