HP Netserver Ultra3 SCSI HBA Guide

15
2 Configuration with SCSISelect
SCSISelect, included with the HP Ultra3 SCSI Host Bus Adapter, enables you
to change SCSI settings without opening the computer or handling the host bus
adapter. SCSISelect also enables you to low-level format or verify the disk
media of your SCSI hard disk drives. The following table lists the available and
default settings for each SCSISelect option.
NOTE The default settings are appropriate for most systems. Run SCSISelect
if you need to change or view current settings, or if you would like to
run the SCSI disk utilities. See the descriptions of each option starting
on page 17.
SCSISelect Options Available
Settings
Default
Setting
SCSI Bus Interface Definitions:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination
LVD/SE Connectors Automatic, Enabled,
Disabled
Automatic
SE Connectors Automatic
Low ON/High ON
Low OFF/High OFF
Low OFF/High ON
Automatic
Boot Device Options:
Boot SCSI ID 0-15 0
Boot LUN Number
1
0-7 0
SCSI Device Configuration:
Sync Transfer Rate (MBytes/sec) 160, 80.0,53.4, 40.0,
32.0, 26.8, 20.0,
16.0, 13.4, 10.0,
ASYN
160