HP Netserver Ultra3 SCSI HBA Guide

3 Microsoft Windows NT

Installation

This chapter explains how to install the HP Ultra3 Family Manager Set driver

adpu160m.sys for Windows NT.

If you are performing a first time Windows NT installation, see “Installing the

Driver When Installing Windows NT” in the next section. If Windows NT is

already installed in your system, see “Installing the Driver When Windows NT

is Already Installed” on page 24.

Installing the Driver When Installing

Windows NT

The adpu160m.sys driver is not embedded on the Windows NT 4.0

installation disks (or CD-ROM) and must be added during Windows NT

installation.

Completing a Fresh Windows NT 4.0 Installation From Floppy

Disk

1. Start your system with the Windows NT Boot Disk in the floppy disk drive.

2. When prompted, insert disk #2 in your floppy disk drive. After a few

moments you will see a blue screen. To setup Windows NT now, press Enter.

3. Press S to skip auto-detection of your SCSI host adapter.

4. Press S again to specify an additional device.

5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk

for Windows NT into your floppy disk drive.

6. Using the arrow keys, select the following driver and press Enter:

Adaptec Ultra3 PCI SCSI Controller (NT4.0)

7. To add other host adapters, press S and repeat from Step 5 for each addi-

tional adapter and insert the appropriate driver disk.