HP Netserver Ultra3 SCSI HBA Guide

If the Parameters Device keys already exist, skip to Step 8 below to begin

entering values. If the keys do not yet exist, you will need to create them by

continuing with Step 4.

4. Clickontheadpu160m key.

5. Select Add Key from the Edit menu; Type Parameters in the Key Name

edit box. Leave the Class edit box blank.

6. ClickontheParameters key.

7. Select Add Key from the Edit menu; Type Device in the Key Name edit

box. Leave the Class edit box blank.

8. To specify a certain host adapter, append Device with the number of the host

adapter. For example, type Device0 for the first host adapter, Device1 for

the second, etc. If you omit the host adapter number, the configuration infor-

mation applies to all Ultra3 Family host adapters.

9. ClickontheDevice key.

10. Select Add Value from the Edit menu. In the Value Name edit box, enter one

of the valid parameter values. Make sure to enter the appropriate data type

for the value. To enter additional values, repeat Steps 8 and 9.

NOTE Changes made with the Registry Editor do not take effect until you

shut down and then restart your system.

Using Driver-specific Parameters

To use the Registry Editor to enter adpu160m.sys driver-specific parameters

that affect the configuration information for SCSI PCI device drivers, follow the

instructions below. A list of valid parameters follows:

NOTE The following parameters are case-sensitive and must be entered

exactly as shown. When entering multiple parameters, each parameter

must be separated by a space.