HP Netserver Ultra3 SCSI HBA Guide

29
8. ClickontheDevice key.
9. Select Add Value from the Edit menu; type Driver Parameters in the Key
Name edit box. Enter REG_SZ asthedatatypeandpressEnter.
10. A String Editor text box appears. Enter valid parameters in the text box.
When entering multiple parameters, each parameter must be separated by a
space.
NOTE Changes made with the Registry Editor do not take effect until you
shut down and then restart your system.
Hot-Plug PCI Feature
Hot-Plug PCI is supported by the Windows NT 4.0 driver adpu160m.sys.You
will need a system that supports Hot-Plug PCI as well as associated Hot-Plug
PCI application software in order for Hot-Plug PCI to work. Do not enable the
Hot-Plug PCI feature unless your system is Hot-Plug PCI capable and you wish
to use the Hot-Plug PCI feature.
Follow the instructions below to enable Hot-Plug PCI support in the driver:
1. Insert the HP Ultra3 Family Manager Set disk for Windows NT into drive A.
2. Select Run from the Start menu.
3. Type a:\nt4\hotp160m.reg and press Enter.
4. Click OK.
5. Reboot the system.
6. See the note following these instructions.