HP Netserver Ultra3 SCSI HBA Guide

37
4 Microsoft Windows 2000
Installation
This chapter explains how to install the HP Ultra3 Family Manager Set driver
for Windows 2000.
If you are performing a first-time Windows 2000 installation, see Installing the
Driver When Installing Windows 2000. If Windows 2000 is already installed in
your system, see To Update the Driver When Windows 2000 is Already Installed
on page 37.)
Installing the Driver When Installing
Windows 2000
1. Start your system with the Windows 2000 Operating System CD-ROM disc
in your CD-ROM drive.
NOTE When using a CD-ROM drive to install Windows 2000 from the
bootable CD-ROM, make sure Bootable CD-ROM support is enabled
in either the system or SCSI BIOS setup utility. If these options are
not available, boot from the Windows 2000 floppy disks.
2. You may see a message:
Press any key to boot from CD.
3. After Windows 2000 has completed installation, please reinstall your SCSI
driver from the Device Manager. Follow the steps in “Installing the Driver
When Windows 2000 is Already Installed” on page 37 to ensure the desired
driver is installed.
Installing the Driver When Windows 2000 is
Already Installed
To update or install the driver if Windows 2000 is already installed, follow these
instructions: