HP Netserver Ultra3 SCSI HBA Guide

10. To install additional adapters, follow the procedures from

Step 4.

11. When complete, select Continue to complete the installation.

DOS Drivers for CD-ROM Access

The CD-ROM drivers need to be installed only if DOS access to a CD-ROM

drive attached to a SCSI host adapter is required. If NetWare is already

installed, or if the CD-ROM drive is not connected to a SCSI adapter, these

drivers do not need to be copied or installed. However, you may choose to

install these drivers if you are having trouble accessing your CD-ROM from

Netware.

NOTE You do not need these drivers for Windows NT or UNIX.

Install CD-ROM Drivers on a DOS Bootable Hard Disk

The following systems files should be modified:

• config.sys

• autoexec.bat

1. Copy the files aspi8u2.sys and aspicd.sys from the DOS directory of the

Ultra3 Family Manager Set disk to your C drive. At the DOS prompt, type

the following lines and press Enter after each line:

mkdir c:\scsi

copy a:\dos\*.* c:\scsi

2. Modify config.sys for loading aspi8u2.sys and aspicd.sys,whichis

necessary for connecting a CD-ROM. Either create this file in C:\ if you do

not currently have a config.sys, or add these lines to the existing config.sys

file. Note that you may need to change the path for the drivers.

device=c:\scsi\aspi8u2.sys /d

device=c:\scsi\aspicd.sys /d:aspicd0

3. Modify autoexec.bat for loading mscdex.exe. Either create this file in C:\

if you do not currently have autoexec.bat, or add these lines to the existing

autoexec.bat file: c:\dos\mscdex.exe /d:aspicd0 /m:12