HP Netserver Ultra3 SCSI HBA Guide

57
multlun_targets= 0-FFFF FFFF A bit mask to enable LUNs on
selected targets. By default,
LUNs on all targets are enabled.
This bit mask is entered in hex
(see “Bit Mask Options” on
page 58).
slot=
0-xxxx
b
0 Defines a physical slot number
for the host adapter. If 0 is
specified, or if this option is not
specified, then the driver loads
for all Ultra3 host adapters.
verbose= yes, no no Displays host adapter
configuration information at load
time.
a.Many multiple-LUN and removable-media devices are changers or magazines. Some of these are only
supported by the driver through an ASPI driver provided by the hardware vendor.
b.The values can vary and are dependent on the system configuration.
Option Values Default Description