Installation Guide for Compaq 4000/7000 Racks

Installation

3. Install two screws through the two holes on either side of the NetServer

front panel (see Figure 3-6) and into the rack nuts in the columns

(previously installed).

Figure 3-6. Securing the NetServer to the Rack Columns

4. Replace the hot-swap disk modules into the NetServer.

Installing the Bezel

This NetServer ships with bezel anchors for use with an HP-rack bezel. In

order to install the bezel for use with a Compaq rack, the HP-bezel anchors

must be replaced with Compaq-bezel anchors.

1. Remove the two screws that secure each bezel anchor to each end of the

NetServer front panel, and remove the anchors (see Figure 3-7).