Installation Guide for Compaq 4000/7000 Racks

1
1 Introduction
This document describes how to mount an HP NetServer LPr into a Compaq
®
model 4000- or 7000-series rack enclosure. Refer to the HP NetServer LPr
Installation Guide that came with the NetServer for instructions on adding
accessories to and configuring the NetServer. The HP NetServer LPr is shown in
Figure 1-1.
Figure 1-1. HP NetServer LPr
WARNING To prevent the rack from tipping over and causing equipment
damage or bodily injury, be sure that the stabilizing, anti-tip
feature is installed on this rack enclosure (see Figure 1-2).
WARNING To prevent the rack from tipping over and causing equipment
damage or bodily injury, do not extend more than one piece of
equipment at a time out of the front of the rack enclosure.
Be sure that the stabilizing, anti-tip feature is installed on the rack enclosure in
which you are installing the HP NetServer LPr. This feature consists of two "feet"