HP Network ScanJet 5 Scanner - Administrator's Guide

In order to configure and use the scanner, the following conditions must
be met:
• You must have supervisor privileges on at least one of the network
environments.
• The scanner must be physically connected to the network at the control
panel, as described in the Getting Started Guide.
• You must specify the protocol stack and the frame type in the
Configuration menu at the control panel, as described in the Getting
Started Guide.
• You must configure the scanner on at least one network environment, as
described in this chapter.
• At least one destination must be added to the public destination list (or a
fax server must be configured), as described later in this chapter.
Destinations are selected from a pool of resources available for the
network environments configured for the selected scanner. Once a
destination is added, it appears in the public destination list displayed at
the scanner control panel. Using HP Network ScanJet 5 Utility,
registered users can select destinations from the public list and include
them in their private destination lists.
16 Initial Software Configuration EN