HP Network ScanJet 5 Scanner - Administrator's Guide

Configuring Fax Servers and Adding Fax
Destinations
Configure installed fax servers and fax destinations through the Faxes
tab of the Configuration dialog box.
A fax server must be configured and then selected for the scanner before
a user can scan a document to a fax destination.
See the HP Network ScanJet 5 Scanner web page
(http://www.hp.com/go/network-scanning) or contact an authorized HP
dealer for the most updated list of supported LAN fax servers.
For information regarding maintaining fax server and fax destination
information, see the online Help.
The following procedure is an example you can use for a configuration
reference.
To configure and then select a LAN fax server
1 In the Fax Server box on the Faxes tab, click Configure to display the
Lan Fax Configuration dialog box.
2 In the Supported Lan Fax Product box, select the vendor for the LAN
fax that is connected to the network.
3 Click Configure to display the Fax Server Selection dialog box.
4 In the Available Network Servers box, select the network server to
supply the first part of the Fax Server Directory location.
5 In the Fax Server Directory box, type the server and directory where the
fax system files are stored, or click Browse to locate the directory.
6 In the Scanner ID box, type the ID for the scanner, if appropriate. For
Biscom servers, this is the name used in the Biscom administration
software to define the print queue associated with the scanner.
7 Click OK. The Lan Fax Configuration dialog box is once again
displayed.
2
Initial Software Configuration
EN Initial Software Configuration 25