HP Network ScanJet 5 Scanner - Administrator's Guide

To specify fax transmission options
1 On the Faxes tab, in the Fax Server box, click Configure.
2 In the Lan Fax Configuration dialog box, in the Supported LAN Fax
Products box, select the vendor for the LAN fax that is connected to the
network.
3 In the Fax Option box, click Advanced to display the Fax Transmission
Advanced Options dialog box.
4 In the Transmission Options box, enter the number of retries and the
retry rate, and select the maximum transmission speed and the
resolution. Select ECM to enable the Error Connection Module, which
checks the fax for accuracy every few thousand pixels. ECM takes
longer than manual transmission, but results in clearer fax images.
5 In the File Format box, select the file format in which the faxes will be
transmitted.
Note This option is not available for all LAN fax products.
6 If the fax server does not support sending notifications to users, select
Diable Notification To Users.
7 If the scanner is connected to a network printer, select Enable
Transaction Report Printing; in the Selected Printer box, you can select a
printer to print the fax transaction reports.
8 When you’ve finished configuring the server, click OK.
To add new fax destinations
1 On the Faxes tab of the Configuration dialog box, in the Control Panel
Faxes box, click Change to display the Faxes dialog box.
2 Under Current Settings, click New.
3 In the Control Panel Name box, type a name for the fax destination, as it
will appear on the scanner control panel.
4 In the Fax Number box, type the fax number for the new fax destination.
Use the format specified by your fax server.
5 In the Retry box, type the number of attempts that should be made to
dial the fax destination before canceling the request.
6 In the Accounting Code box, enter the accounting name you’ve
associated with the fax destination. This is optional. If left empty,
JetAdmin uses the accounting information entered for the fax server.
7 Click Apply to confirm the fax destination. The fax destination is
displayed in the Control Panel Faxes list.
26 Initial Software Configuration EN