HP Network ScanJet 5 Scanner - Administrator's Guide

Re-initializing the Scanner
You can re-initialize (reboot) the currently selected scanner remotely if
you have supervisor privileges on at least one of the network
environments configured in the scanner.
To re-initialize the scanner
1 On the Tools tab of the Properties dialog box, click the Reset icon.
2 In the Commands box, click Re-initialize.
3 When the message Re-initialize the scanner is displayed,
click OK.
Resetting the Scanner
Caution Resetting the scanner will erase all scanner configuration information.
You will need to reconfigure the scanner after a reset.
You can restore the original factory defaults on the selected scanner, You
can resterasing all data stored on the scanner’s internal hard disk. Since
all the scanner data distributed on the network file servers is cleared, you
must have supervisor access for each of the servers. Only those network
environments currently running and on which you have supervisor
access will be cleared.
To reset the scanner
1 On the Tools tab of the Properties dialog box, click the Reset icon.
2 In the Commands box, click Reset to Factory Defaults.
3 When the message This will erase ALL data from the
selected scanner. Reset scanner to factory
defaults? is displayed, click OK.
3
Scanner Maintenance
EN Scanner Maintenance 33