HP Network ScanJet 5 Scanner - Administrator's Guide

Network Errors
Error Message Error Description Actions
101
Rebooting...
Please wait. The network scanner
is rebooting.
No action is required. The scanner
has received a reset command
from the HP JetAdmin software.
When the reboot finishes, the
scanner will be ready for use
again.
102
Control Panel
Locked...
The scanner is in a configuration
phase.
No action is required. The scanner
has received a configuration
command from the HP JetAdmin
software. When configuration
finishes, the scanner will be ready
for use again.
103
Too Many Fax
Numbers Entered
Press any key...
The scanner reached the
maximum allowed number of
temporary fax numbers.
No action is required.
104
No Users Found
Press any key...
105
No Destinations
Found
Press any key…
106
No Printers Found
Press any key...
The scanner has been correctly
initialized, but the destination pool
is empty (not an error).
Note: This could happen after a
restorefromanoldbackupif
destinations were removed from
the network after the date of the
old backup.
Add missing
users/destinations/printers to the
scanner.
In the HP JetAdmin software,
configure the scanner and create
a list of users/destinations/printers.
If the problem persists,
unconfigure the scanner and
configure it again from scratch.
If the problem persists, call HP
Support Service.
107
No Prv Destinations
Found
Press any key...
The private destinations related to
the user validated at the control
panel have not been previously
configured.
Check that the user has correctly
configured private destinations.
Install the HP Network ScanJet 5
Utility on the user’s computer, then
configure the user’s private
destinations.
If the problem persists, call HP
Support Service.
108
Destination Locked
<User Name>(err)
The selected destination has the
workarea locked.
Use the HP Network ScanJet 5
Utility to unlock the workarea.
48 Troubleshooting and Error Messages EN