HP Network ScanJet 5 Scanner - Administrator's Guide

To begin scanner configuration
1 From the JetAdmin software main window, select the scanner you want
to modify.
Note If you don’t see the scanner listed, press the [F5] key to refresh (update)
the window.
2 From the Device menu, choose Modify, or click the Modify icon on the
toolbar. The Configuration for HP Network ScanJet 5 Scanner dialog
box appears.
3 Enter information on the tabs of the Configuration dialog box.
4 Click OK to close the dialog box (or Finish if you are in Interview
mode). The changes take effect.
Note
The information included in this chapter describes how to configure the
scanner initially. Please refer to online Help for information regarding
how to maintain the configuration.
Now that you have installed the scanner software, you will need to use
the HP JetAdmin software to connect the scanner to the network.
To complete the scanner configuration
1 In the Configuration dialog box, click the General tab.
2 In the Description box, type a description of the scanner, such as its
location or an explanation of the model. This field is optional. The
description appears in the main window of the JetAdmin software. The
scanner name is shown here and cannot be changed.
18 Initial Software Configuration EN