HP Network ScanJet 5 Scanner - Administrator's Guide

Error Message Error Description Actions
109
Invalid Destination
<User Name>(err)
The user corresponding to the
selected destination is no longer
defined in the configuration. The
job has been canceled.
Use the HP JetAdmin software to
reconfigure the destination name
in the user pool.
110
Protocol Stack
Unconfigured
Press any key...
The correct Protocol Stack must
be selected before exiting the
special menus.
At the scanner control panel,
select the correct Protocol Stack.
111
Printer not found
<Printer Name>(err)
The print queue selected as the
scanning destination cannot be
found. The job has been canceled.
Use the HP JetAdmin software to
configure the printer.
112
Send to User Error
<User Name>(err)
The HP Network ScanJet 5
scanner detected an error while
sending a job to the user. The job
has been canceled.
Check if the maximum available
disk space for the workarea owner
has been reached.
Check if the server disk is full.
Check the LAN cable.
Check if the HP Network ScanJet
5 scanner has create and write
permissions in the workarea
owned by the selected destination.
If the user workarea is configured
in an NT or LAN Server
environment, check if the HP
Network ScanJet 5 scanner
service (daemon) is still active.
If the destination is an e-mail
address, check if the HP Network
ScanJet 5 Scanner service
(daemon) has been upgraded to
e-mail functionality.
Check if the network scanner
object still exists in the server
bindery.
4
Troubleshooting
EN Troubleshooting and Error Messages 49