HP Network ScanJet 5 Scanner - Administrator's Guide

Error Message Error Description Actions
133
General User
Disabled
Press any key...
134
Fax Server Disabled
Press any key...
The scanner is working, but the
general user or fax server is
disabled.
Use the HP JetAdmin software to
configure the general user or fax
server.
135
To o M a n y
Destinations
Please Deselect
Some of Them
Press any key...
There are too many destinations
selected on the scanner’s control
panel.
Deselect some destinations.
140
Network Error
Network Load
Error(err)
HP Network ScanJet
5 halted
An error occurred while loading or
connecting to the network stack
(Ethernet), or there was a problem
accessing the ring (Token Ring),
or there was a problem initializing
the TCP/IP stack.
Check the LAN cable.
Check if the server is available.
If the workarea is configured in an
NT or LAN Server environment,
check if the HP Network ScanJet
5 scanner service (daemon) is still
active.
If the problem persists, call HP
Support Service.
141
Network Error
NetWare Init Error
(err)
HP Network ScanJet
5 halted
An error occurred during the
NetWare protocol initialization.
Turn the scanner off and on.
If the problem persists, call HP
Support Service.
142
Network Error
SNMP Init Error (err)
HP Network ScanJet
5 halted
An error occurred while initializing
SNMP or when MIB was
registered.
Call HP Support Service.
143
Network Error
SAP Init Error (err)
HP Network ScanJet
5 halted
An error occurred while initializing
SAP.
Call HP Support Service.
4
Troubleshooting
EN Troubleshooting and Error Messages 51