HP Network ScanJet 5 Scanner - Administrator's Guide

Administrative Software Error Messages
The errors in this section are divided into two groups: HP JetAdmin
software errors and fax errors.
HP JetAdmin Software Errors
Error Message Error Description Actions
Not enough memory
to continue the
operation
There is not enough memory
either to run HP JetAdmin
software or to perform a specific
action.
Free as much memory as possible
by closing other applications and
try again.
Restart the HP JetAdmin software.
The domain
controller of an
expected domain is
not responding
The NT or LANServer domain
controller is not responding.
Check the LAN cable.
Make sure the domain controller is
available.
Make sure that the network
configuration of your LAN has not
changed during your HP JetAdmin
software session.
An expected
sharename does not
exist anymore
The sharename is
not valid
The sharepoint of an NT or
LANServer domain is not
responding.
Check the LAN cable.
Make sure that the network is
accessible from the PC running
the HP JetAdmin software.
Make sure that the network
configuration of your LAN has not
changed during your HP JetAdmin
software session.
The system cannot
communicate with
the network
The application is running on a
system that is not properly
configured to communicate on the
expected networks.
Make sure the network is
accessible from the computer
running the HP JetAdmin software.
Make sure the network protocols
needed for the HP JetAdmin
software are installed (TCP/IP or
NetWare).
62 Troubleshooting and Error Messages EN