User's Guide

5157/5157 ACL S-Series DLT Subsystems Installation/Users Guide

Installing and Configuring the 5157/5157 ACL Digital Linear Tape Subsystem

for S-Series Servers

7-10

Group and slot labels help to locate CRUs that need service. Some

software might show the location of a CRU using abbreviations for

group, module, and slot. For example the Subsystem Control

Facility (SCF) storage subsystem might display the location of a

PMF CRU as:

PMF.GRP-1.MOD-1.SLOT-50

For more information on system organization, group numbering, or

labeling in a Himalaya S-Series server, refer to the Himalaya S-

Series Planning and Configuration Guide.

7.3.2.3 Completing the PMF CRU Configuration Form

If a tape drive CRU is to be connected to a PMF CRU, document

the configuration of the PMF CRU using a PMF CRU

Configuration Form. This form documents configurable entities

associated with the connectors on a PMF CRU. It also provides

information about the tape drive to be connected to the PMF CRU.

Note: The SCSI passthrough terminator is preinstalled on the

differential SCSI port.

Figure 7-4 shows an example of a completed PMF CRU

Configuration Form. For a blank PMF CRU Configuration, refer

to the Himalaya S-Series Planning and Configuration Guide.

The SCSI Port information block must completed on the form if a

tape drive is to be attached to a PMF CRU:

• Enter the product number of the tape drive in the Product

Number field. The correct product number is 5157.

• Enter the Subsystem Control Facility (SCF) name of the tape

drive in the SCF Name field.