5158ACL Tape Drive Installation and User's Guide

Configuring the Tape Drive for the NonStop S-Series
Server
5158ACL Tape Drive Installation and User’s Guide—524955-002
4-2
Adding the ACL Unit and the Tape Drive
Adding the ACL Unit and the Tape Drive
ServerNet/DA
To add the tape drive to the server configuration database, use the SCF ADD SCSI
command to add the ACL unit. Use the SCF ADD TAPE command to add the tape
drive. Before issuing these commands, check that the tape drive is installed
properly.
To add the ACL unit:
-> SCF
-> ADD SCSI $ACLLIB, SENDTO STORAGE, PRIMARYLOCATION
(1,1,51), PRMARYSAC 1, SCSIID 3, PRIMARYCPU 0, BACKUPCPU 1
-> START SCSI $ACLLIB
-> INFO SCSI $ACLLIB, DETAIL
To add the tape drive:
-> SCF
-> ADD TAPE $ACLTAP, SENDTO STORAGE, LOCATION (1,1,51), SAC
1, DEVICEID 5, PRIMARYCPU 0, BACKUPCPU 1
-> START TAPE $ACLTAP
-> INFO TAPE $ACLTAP, DETAIL
For complete details about the ADD and INFO commands, including command
syntax, see the SCF Reference Manual for the Storage Subsystem.
PMF CRU
To add the tape drive to the server configuration database, use the SCF ADD SCSI
command to add the ACL unit. Use the SCF ADD TAPE command to add the tape
drive. Before issuing these commands, check that the 515 ACL is installed
properly.
To add the ACL unit:
-> SCF
-> ADD SCSI $ACLLIB, SENDTO STORAGE, PRIMARYLOCATION
(1,1,50), SCSIID 3, PRIMARYCPU 0, BACKUPCPU 1
-> START SCSI $ACLLIB
-> INFO SCSI $ACLLIB, DETAIL
Note. The tape drive product consists of two parts: there is the tape drive and the ACL unit.
The ACL unit is a robot that mounts tape cartridges into the tape drive.