5190/5194 Modular Tape Subsystem Manual

Contents
5190/5194 Modular Tape Subsystem Manual—426878-002
viii
Tables
Figure 4-9. Loading a Cartridge Tape Into a Tape Drive Without an ACL 4-25
Figure 6-1. Removing a Tape Drive CRU 6-7
Tables
Table 1. Summary of Contents xi
Table 1-1. Releases Supporting 5190 and 5194 Tape Drives 1-2
Table 1-2. 5190 and 5194 Cartridge Tape Compatibility 1-5
Table 1-3. Cartridge Capacities 1-6
Table 1-4. Tape Controller Comparison for NonStop Himalaya K-Series
Servers 1-10
Table 1-5. Interface Component Comparison for NonStop Himalaya S-Series
Servers 1-13
Table 2-1. Subchannel Addresses for I/O Controllers 2-14
Table 3-1. NonStop Himalaya K-Series Tape Subsystem Installation Tasks 3-2
Table 3-2. NonStop Himalaya S-Series Tape Subsystem Installation Tasks 3-3
Table 3-3. Drive CRU Device IDs for Each Controller or Adapter 3-5
Table 3-4. Modular Storage System Component Weights 3-8
Table 3-5. Environmental Requirements for the Tape Drive Module 3-9
Table 3-6. AC Power Requirements for the Tape Drive CRU 3-9
Table 3-7. AC Power Cord Current and Voltage Ratings 3-10
Table 3-8. Modular Tape System Connecting Tasks 3-22
Table 4-1. Common 5190 and 5194 Tape Drive Operations 4-2
Table 4-2. Environmental Requirements for Cartridge Tapes 4-2
Table 4-3. ACL Front-Panel Status Indicator LEDs 4-8
Table 4-4. ACL Operator Buttons 4-9
Table 4-5. Cartridge Position Indicator Codes 4-10
Table 4-6. 5190 and 5194 Tape Drive CRU Front-Panel Status Indicator
LEDs 4-23
Table 4-7.
Operator Message Types and Priorities 4-29
Table 4-8.
Common Operator Messages 4-29
Table 4-9. Error Messages and Check Codes 4-30
Table 4-10. Methods for Controlling Compression on a 5190 Tape Drive 4-45
Table 4-11. Buffered Mode Performance 4-56
Table 6-1. Troubleshooting a BEB 6-2
Table A-1. Component Part Numbers A-1