5190/5194 Modular Tape Subsystem Manual

5190/5194 Modular Tape Subsystem Manual—426878-002
xi
About This Manual
This manual describes how to install, operate, and maintain the 5190/5194 modular
tape subsystem.
Who Should Use This Manual
This manual is intended for users of NonStop Himalaya K-series and S-series servers
who want to perform the following functions on the 5190/5194 modular tape
subsystem:
•
System planning and installation
•
Configuration
•
System management
•
Operation
What Is in This Manual
Table 1 summarizes the contents of this manual.
Table 1. Summary of Contents (page 1 of 2)
Section Title This section . . .
1 Introduction to the Modular
Tape Subsystem
Introduces the modular tape subsystem and the
components that make up and support the
subsystem. It is designed to familiarize you
with the modular tape subsystem before you
install or operate the subsystem.
2 Configuring the Modular Tape
Subsystem
Tells you how to configure the modular tape
subsystem. It includes configuration forms and
provides examples for configuring the
subsystem using either the Configuration Utility
Program (COUP) or the Subsystem Control
Facility (SCF).
3 Installing the Modular Tape
Subsystem
Tells you how to plan for and install the modular
tape subsystem. It includes hardware
installation and configuration procedures. Read
the entire section before installing the
subsystem.
4 Operating the Cartridge Tape
Drive and ACL
Provides basic operating procedures for the
5190 and 5194 tape drives and the automatic
cartridge loader (ACL).
5 Using TMDS or the TSM
Package
Describes Compaq Tandem Maintenance and
Diagnostic System (TMDS) and Compaq
Tandem Service Management (TSM) support
for the modular tape subsystem.