5190/5194 Modular Tape Subsystem Manual

5190/5194 Modular Tape Subsystem Manual—426878-002
6-1
6
Adding, Removing, and Replacing
CRUs
This section tells you how to add, remove, and replace modular tape subsystem
components that are customer-replaceable units (CRUs).
Information about replacing CRUs is documented in the following manuals:
Unless stated otherwise, each of the following topics applies to both NonStop Himalaya
K-series servers and NonStop Himalaya S-series servers.
Procedures That Require a Service Provider
Not all replacement procedures for the modular tape subsystem can be performed by
users at the installation site. The following procedures must be performed by a trained
service provider:
•
Troubleshooting or repairing a 5190 or 5194 tape drive CRU
•
Troubleshooting or repairing an ACL
•
Disassembling a module
•
Adding a second tape drive CRU to an installed module
•
Adding an ACL to an installed module
•
Adding a module to an installed modular storage system stack
•
Extracting a cartridge tape from a failed drive
Topic Page
Procedures That Require a Service Provider
6-1
Replacing a BEB 6-2
Replacing a 5190 or 5194 Tape Drive CRU 6-5
Returning a Tape Drive CRU to Compaq 6-10
Replacing a Cleaning Cartridge in an ACL 6-10
Removing a Cleaning Cartridge From an ACL 6-11
Replacing a Controller (NonStop Himalaya K-Series Servers) 6-12
Replacing a NonStop Himalaya S-Series Server Adapter 6-15
K-Series Servers Manuals
NonStop Himalaya
S-Series Servers Manuals
Himalaya K100 and K1000/K2000 Support Guide
Himalaya K10000/K20000 Support Guide
Himalaya S-Series Hardware Support
Guide