5190/5194 Modular Tape Subsystem Manual

Safety and Compliance
5190/5194 Modular Tape Subsystem Manual—426878-002
Statements-3
Consumer Safety Statements
Service Clearance
Note the following position information before beginning the installation:
You should allow a clearance of 60 to 90 centimeters (24 to 36 inches) at the front and
90 centimeters (36 inches) at the rear of the cabinet for adequate ventilation and
servicing.
Dégagement pour l'entretien
Notez les informations suivantes relatives à la position, avant de commencer
l'installation :
Vous devez laisser un dégagement de 60 à 90 centimètres à l'avant de l'armoire, et 90
centimètres à l'arrière, pour permettre une ventilation et un entretien corrects.
Procedures That Require a Service Provider
While some simple replacement procedures for the modular tape subsystem can be
performed by users at the installation site, the following procedures must be performed
by a service provider trained by Compaq:
•
Troubleshooting or repairing the 5190 or 5194 drive CRU
•
Troubleshooting or repairing the automatic cartridge loader (ACL)
•
Disassembling the module
•
Adding a second drive CRU to an installed module
•
Adding an ACL to an installed module
•
Adding a module to an installed modular storage system stack
•
Extracting a cartridge tape from a failed drive
Any troubleshooting or repair of the drive CRU or ACL can be done only at the factory
by a service provider trained by Compaq. To contact a service provider, call the
Compaq Global Customer Support Center (GCSC).
Note. The modular storage system can be serviced only from the rear.
Remarque. L'entretien du sous-système 5190/5194 ne peut être fait que par l'arrière.
WARNING. With the ACL option, the 5190 or 5194 drive CRU can weigh up to 34 kilograms
(75 pounds). To avoid injury, always use at least two people to lift the drive CRU out of the
module.