5190/5194 Modular Tape Subsystem Manual

Configuring the Modular Tape Subsystem
5190/5194 Modular Tape Subsystem Manual—426878-002
2-20
Completing the PMF CRU or IOMF CRU
Configuration Form
Completing the PMF CRU or IOMF CRU Configuration Form
If you plan to connect a tape drive CRU to a PMF CRU or IOMF CRU, you document
the configuration using a PMF CRU Configuration Form, PMF 2 CRU Configuration
Form, IOMF CRU Configuration Form, or IOMF 2 CRU Configuration Form. This form
documents configurable entities associated with the connectors on the CRU. It also
provides information about the tape drive to be connected to the CRU.
Figure 2-3 shows an example of a completed PMF CRU Configuration Form.
Figure 2-4 on page 2-22 shows an example of a completed IOMF CRU Configuration
Form. For blank configuration forms, refer to the Himalaya S-Series Planning and
Configuration Guide.
To complete the SCSI Port information block on the form:
•
Enter the product number of the tape drive in the Product Number field. Allowable
product numbers are 5190 and 5194.
•
Enter the Subsystem Control Facility (SCF) name of the tape drive in the SCF
Name field, for example, $TAPE0.
•
Enter the product number of the SCSI cable you will use with this tape drive in the
SCSI Cable field. You must use one of the SCSI cables listed in Appendix A, Part
Numbers.
For instructions on completing the rest of the configuration form, refer to the Himalaya
S-Series Planning and Configuration Guide.